Rm-materials-handling VARIABLE SPEED CONTROLS ControlMaster Select Servi Manual do Utilizador descarregar pdf (Página 3)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

3/46

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

1 CAUTION

# This manual rev6.0 is for inverter rev 1.0 with software D2S2V051.

! Before starting, read the instructions carefully.

! Verify all of the connections are in accordance to the drawings.

! Verify the motor supply is connected correctly, faulty connection will destroy the inverter.

! Check the device cover is properly installed.

! High voltages are present in this device. Switch the power off and after the display turns off,

wait 5 minutes before opening the cover.

! Insulation resistance test with a megger multimeter requires special precautions.

! Do not make any measurements inside the device when it is connected to the main supply.

! Do not touch the components on the circuit boards. Electrostatic discharge may cause

damage or destroy the IC-circuits.

! Check all ventilation holes are clear and unobstructed.

! Check that hot air coming from the brake resistors does not cause any danger.

! Do not make any inspections unless the supply has been disconnected by the main switch.

! It is forbidden to use radiophones or portable phones near this device with the doors open.

! All the doors and covers must be closed during crane operation.

! Drive is not intended to be used in a low-voltage public network, which supplies domestic

premises. Radio frequency interference is expected if used in such a network.

1 2 3 4 5 6 7 8 ... 45 46

Sem comentários

Rm-materials-handling VARIABLE SPEED CONTROLS ControlMaster Select Servi Manual do Utilizador Página 3