Rm-materials-handling ELECTRIC CHAIN HOISTS LoadMate Chain Hoist LM 10 S Manual do Utilizador Página 12

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 11
LM10 STEPLESS I&M MANUAL/EN/11.30.2010
12/99
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
2.5 Electrical Connection
The user / owner must provide the main power supply hardware (cable, conductor bar, fuses, disconnect
switch, etc.).
m
CAUTION: Make sure that the power supply voltage is the same as that shown on hoist serial
plate / nameplate.
m
CAUTION: Make sure that fuses and other current overload devices are in place to protect the
power supply.
m
CAUTION: Make sure that power cable or conductors have sufficient capacity to maintain the
hoist supply voltage by ±5 percent of nominal voltage under all operating conditions. Poor
voltage regulation may cause motor overheating or sluggishness, and chattering / inoperative
motor brake(s) and controls.
m
CAUTION: Do not use power supply cables with solid conductors.
m
WARNING: Failure to properly ground the hoist presents the danger of electric shock.
m
WARNING: An improper or insufficient ground connection creates an electrical shock
hazard when touching any part of the hoist or trolley.
Vista de página 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 98 99

Comentários a estes Manuais

Sem comentários